1) Remove Battery Pack 2) Pess and Hold the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. 3) Press the Program button once more. When the LED flashes green and you hear…
Installing the Kwikset Smartcode 912 Door Lock
Installation Adding the Lock to Your Home Automation Network Make sure that the RF daughter card is properly installed, seated, and connected. On the locks interior assembly, press the ‘A’ button 4 times to place the device…
Defaulting the Kwikset SmartCode 910 and 914 Deadbolt
This article is applicable to all of the following models. Kwikset SmartCode 910 Deadbolt Kwikset SmartCode 914 Deadbolt 1) Remove Battery Pack 2) Pess and Hold the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED…
Installing The Kwikset SmartCode 910 and 914 Door Locks
This article is applicable to all of the following models. Kwikset SmartCode 910 Deadbolt Kwikset SmartCode 914 Deadbolt Adding the Lock to Your Home Automation Network Make sure that the RF daughter card is properly installed, seated, and connected. On the locks interior assembly, press the ‘A’ button 4 times to…
Deleting/Modifying Door Locks
To delete a door lock, click Settings on the toolbar to display the settings screen. Click on Door Locks to display the door locks settings page. Click the icon next to the door lock you want to modify. OR Click the icon next to the door lock that you want to delete and…
Adding a Door Lock
You can add door locks when you activate Touchstone or at a later time. If you want to add a door lock that was not included with the original Touchstone package, make sure your service provider supports it. To add door locks, click Settings on the tool bar to display the settings…
Programming the Yale Real Living Push Button Dead Bolt 210
Feature Programming Through Menu Mode Using Master PIN Code 1. Enter the 4-8 digit Master PIN code followed by the key. 2. Enter digit corresponding to the function to be performed followed by the key. Note: If the lock is connected to a network controller, it is recommended that it…
Installing the Yale Real Living Push Button Dead Bolt
Unpack the Lock The lock is packed representative of how it will install on the door. Before installing the lock on the door: A. Inside escutcheon 1. Loosen the screw (Phillips #2) holding the battery cover(The screw remains attached to battery cover). 2. Slide the battery cover up…
Defaulting the Yale Real Living Deadbolt 210/220/240
The following procedure returns the lock to its factory defaults by deleting all user codes (including the Master PIN code*) and returning all programming features to their original default settings (see below). 1. Remove the batteries and then remove the interior escutcheon to access the reset button. 2. The reset…
Programming the Yale Real Living Touchscreen Deadbolt 220/240
A unique Master PIN Code must be entered prior to any further programming of the lock. Definitions All Code Lockout Mode: This feature is enabled by the Master PIN code. When enabled, it restricts all user PIN code access (except the Master PIN code). When the unit is in Lockout…