Installation Disconnect power before installing a LED Bulb. • Install LED Bulb to light fixture. LED Bulb can be installed to lighting fixture and E26 Base Socket. • If you have and want to connect to home controller, please refer to the controller’s user guide for instructions on how to pair this…
Defaulting the LG Zigbee Smart Bulb(EM35x)
To reset the device to factory resets, turn power off and then on 7 times in rapid succession. The bulb will indicate it has been factory reset by blinking 5 times.
Defaulting the Sercomm Smart Plug(EM358x) (SZ-ESW01)
Remove the Smart Plug from it’s power source. Press and hold the Join/Leave button while plugging the Smart Plug back into the power source. The LED is blinking to indicate an attempt to join the Touchstone network.
Installing the Sercomm Smart Plug(EM358x) (SZ-ESW01)
Installation Put the SZ-ESW01 into wall receptacle. Make sure the receptacle is working properly. If it is controlled by a wall switch, which must be set to ON all the times. Attach the appliance to the SZ-ESW01. Operation Auto Operation: If a power interruption should occur while the device is…
Defaulting the Centralite 3 Series Nightlight Repeater
Remove the Nightlight Repeater from the power source. Hold down the primary button. While holding down the button, plug the Nightlight Repeater back into it’s power source. The Nightlight Repeater should begin to flash Blue, indicating it is attempting to join the Touchstone network. A short green flash indicates successful…
Installing the Centralite 3 Series Night Light Repeater
Getting Started Connecting the Battery Using a Phillips head screwdriver, unscrew and remove the battery door. Connect battery to the connector inside the battery compartment and reinstall battery door. Installing to Outlet Find an open wall outlet and remove the center screw that secures the face plate. Plug the device…
Managing Devices
THIS ARTICLE INCLUDES THE FOLLOWING: Managing Lights Managing Thermostats Managing Sensors Managing Door Locks Managing Lights The Subscriber Portal lets you remotely monitor and control up to 30 light devices. The current state of your light settings is displayed on the Main page. % shows the current dimming percentage of…
Controlling Touchstone
Your Touchstone system uses three things to automate your home…Rules, Modes, and Contacts. Rules Rules are the back bone of Touchstone Platform. No matter how great individual devices are, they are always better when they work together. The Rules Engine provides all of your devices a synergy that is unmatched anywhere…
The Different Types Of Rules
There are four(4) different types of rules that you can set up in your Touchstone system. Scroll through this article or click the type of rule you would like to set up. Schedule: Actions occur regularly on specified times, dates, and date ranges without regard to an additional event. Event:…
Defaulting the SMC Motion Sensor(SMCMT10-Z)
Remove the top cover from the SMCMT10-Z. Remove the battery. Press and hold the enrollment switch in the RF circuit inside the SMCMT10-Z until you replace the battery. Replace the battery while still pressing the enrollment switch then release the switch. The RF LED flashes three times to signal the…