Before you enter programming mode to program the thermostat, the device needs to be in an “off” state. To turn the thermostat off, press the “Mode” button until “Off” appears on the screen.
To enter programming mode: PRESS BETWEEN the hold button and the fan button. Continue to hold and swipe down on the right slider – “01” will display. When the “01” is displayed, it indicates yo are in “programming mode.” Use the + and – buttons to advance through the menu options listed below in the “Menu Options” list.
Note, utilizing the MODE button will exit you from the menu. Utilizing the HOLD button will select the option you desire.
When finished programming, tap the MODE button until the thermostat to EXIT the menu and return to normal operation.
Programming Options
Display Celsius and Fahrenheit……………………….. 1
0- Celsius
1- Fahrenheit (Default)
Heat type (Heat pump / Non Heat pump)…………………. 2
0- Non Heat pump(Default)
1- Heat pump
Heat source (Gas / Electric)…………………………. 3
0- Electric(Default)
1- Gas
Temperature Calibration……………………………… 4
-2.5 – +2.5 Celsius
-4.5 – +4.5 Fahrenheit
(Default) – 0
Set Minimum Heatpoint……………………………….. 5
(Default) – 44 Fahrenheit, 7 Celsius
Set Maximum Heatpoint……………………………….. 6
(Default) – 86 Fahrenheit, 30 Celsius
Set Minimum Coolpoint……………………………….. 7
(Default) – 44 Fahrenheit, 7 Celsius
Set Maximum Coolpoint……………………………….. 8
(Default) – 86 Fahrenheit, 30 Celsius
Set Minimum Deadband………………………………… 9
(Default) – 1.8 Fahrenheit, 1.0 Celsius
Sequence of Operation……………………………….. 10
0- Cool Only
1- Cool with reheat
2- Heat Only
3- Heat with reheat
4- Full Auto
5- Full Auto with reheat
6- Manual (Default)
7- Auto Only
EZ Mode……………………………………………. 11
0- No
1- Yes
Join Network……………………………………….. 12
0- No
1- Yes
Leave Network………………………………………. 13
11- Yes
All others – No
Rejoin Network……………………………………… 14
0- No
1- Yes
Redetect System Type………………………………… 15
0- No
1- Yes
Types Detected
04 – HP TWO COOL TWO HEAT
05 – TWO COOL TWO HEAT
FF – INVALID RELAY CONFIGURATION
Reset……………………………………………… 16
0- No
1- Yes
Factory Reset All…………………………………… 17
11- Yes
All others – No
Display Configuration and Network Settings…………….. 18
Order of Display:
1- PSOC Version Number
2- Ember Version Number
3- Heat Type
4- Heat Source
5- Temperature Calibration
6- Relays Detected
7- Network State
8- Network Channel
9-10- PanID
Reset Counter………………………………………. 19
0-
1- Reset to 0