Inserting the Battery
- Find the locking mechanism on the bottom of the SMCDW01-Z.
- Holding the SMCDW01-Z in one hand, carefully insert the tip of a screwdriver into the locking mechanism.
- Push lightly upwards from the back of the SMCDW01-Z until the back plate separates from the sensor.
- Find the supplied CR2 3-volt lithium battery.
- Find the tamper switch.
- While pressing and holding the tamper switch, insert the battery into the SMCDW01-Z, with the positive (+) end oriented towards the tamper switch. The front panel LED goes ON. G. After 1 second, release the tamper switch. The LED blinks green.
- Replace the SMCDW01-Z back plate. I. Align the magnet next to the SMCDW01-Z. The SMCDW01-Z can now be added to the Touchstone system. Note: Do not physically mount the SMCDW01-Z until you add it to the Touchstone system.
Mounting
To mount the SMCDW01-Z to a wall, door, or window frame, use double-sided mounting tape:
- Identify the locations on the SMCDW01-Z where doublesided mounting tape can be applied.
- Wipe clean the surface where the SMCDW01-Z will be mounted. Dust and particles can reduce the adhesion of double-sided mounting tape you will use to mount the SMCDW01-Z.
- Place the main sensor unit and magnet unit in such a way that when the door or window is closed, the man sensor unit and magnet unit are within 2cm. from each other. When you open the door or window, these two units should separate in proximity. Note: For optimal radio communications, position the SMCDW01-Z vertically against the door/window frame
- Do not mount the SMCDW01-Z directly on or near metal framing or other large metallic objects, which can weaken transmitted radio signal.
- Place the SMCDW01-Z indoors and away from sources of water/moisture and other extreme weather conditions.
- Either screw the bidirectional mounting plate and magnet unit into the wall, door or window frame. Use the supplied screw anchors if attaching the SMCDW01-Z to soft material, such as drywall, AND/OR, peel and attach the double-sided mounting tape to the back of the bidirectional mounting plate and magnet unit to adhere to the wall, door, or window frame.
