Mounting and Installing The sensor can be mounted on a wall or ceiling. For EN approved sites, only ceiling installation is allowed. It must be mounted with its bracket (when it is attached to its bracket the tamper switch is pressed and the sensor automatic reset is performed). 1) Locate the bracket on…
Defaulting SMC Water Sensor
To default the sensor, remove the battery. While pressingthe black Tamper/Default button located near the battery carrier and the wire contacts, insert the battery. Then release the button.
SMC Water Sensor (SMCWA10-Z)
The water sensor allows users to around the clock remotely detect the presence of water to provide early detection of costly leaks and floods that could be caused from sump pumps, water heaters, air conditioners, heavy rains, and more. The SMCWA10-Z consists of a Zigbee transceiver unit, 20ft cable, and…
Visonic MINI Door/Window Sensor (MCT-320-SMA)
MCT-320 SMA is a fully supervised, compact Zigbee door/window contact transmitter, designed primarily for protecting doors and windows. Suitable for any residential or commercial environment this low-profile transmitter gives the added advantage of a particularly small size that allows for highly flexible and virtually invisible installation. The MCT-320 SMA boasts…
Viewing History
History Reports can be viewed in many different ways. All History: List all recent events. Results can be filtered. Mode Changes: Lists the instances when someone changed the mode. Trouble Events: A trouble event indicates that something is wrong with the Touchstone system. Possible problems include connectivity issues, low battery levels…
Deleting/Modifying a Sensor
When you delete a sensor, Touchstone disables any rules that reference the sensor. To delete a sensor, click SETTINGS on the toolbar to display the settings page. Click the type of sensor that you would like to delete to display the sensor’s settings page. Click the icon next to the…
Adding a Sensor
Sensors can be added to your system during activation, or at a later time. If you want to add a sensor that was not included with the original Touchstone package, make sure your service provider supports it. Note: If you are attempting to pair a sensor that has been previously deleted…
Defaulting the CLIP Motion Detector
To default the CLIP Motion Sensor, remove the cover by loosening the screw at the bottom of the unit to expose the circuit board and battery. Remove the battery and press and hold the tamper spring. With the tamper spring held down, insert the battery, immediately release the tamper spring,…
Defaulting the Visonic Pet-immune Motion Detector (NEXT-K85-SMA)
Open the cover by loosening the small screw at the bottom of the sensor and expose the circuit board and remove the circuit board. Locate the battery on the back side of the board and remove it. With the battery removed, press and hold the tamper spring. Reinsert the battery…
Defaulting the Visonic Water Sensor (MCT-550 SMA)
To default the Water Sensor, remove the cover by loosening the screw found at the top of the unit. Remove the battery and depress the tamper spring. Reinsert the battery, immediately release the tamper spring, and press and release the tamper spring again. The LED on the sensor will begin…