To enter programming mode: PRESS FAN and MODE buttons at the same time. Then press the UP ARROW button while the fan and mode button are still held. The clock display will change to indicate which programming mode you’re currently in. The display will start at 10:00. If there is ever…
Testing the Thermostat(AZELA)
Testing Thermostat Operation After completing any necessary configuration make sure the thermostat is in Cool mode by pressing the MODE button until Cool is displayed at the bottom of the screen. Make sure the system is not calling for Cooling by setting the setpoint several degrees above the room temperature.…
Thermostat Installation(AZELA)
Before you begin installing your thermostat, please be advised that It is always a good practice to consult the owner’s manual for your HVAC system. If necessary, consult an HVAC technician to ensure proper installation. Locating the Thermostat If this is to replace an existing thermostat, just use the existing…
Installing the Carbon Monoxide Sensor (MCT-442)
Mounting and Installing The sensor can be mounted on a wall or ceiling. For EN approved sites, only ceiling installation is allowed. It must be mounted with its bracket (when it is attached to its bracket the tamper switch is pressed and the sensor automatic reset is performed). 1) Locate the bracket on…