Find a suitable location for the wireless radio. Note: For best signal strength, place the wireless radio as high as possible. Find a suitable location to place the water sensor probe. Examples include baseboards, drip pans, etc. Placement should be as close to the surface as needed. The sensor is…
Installing the Visonic Water Sensor
Installaing Attach the flood sensor near the floor. Secure the flood sensor and its cable to the wall using the three wire clamps. One clamp should be fastened immediately above the flood sensor. The flood sensor should be installed only in a vertical position, and facing downward. The remaining two clamps can be used…
Visonic Water Sensor (MCT-550 SMA)
MCT-550 SMA is a fully supervised wireless flood detector, designed to detect the presence of water. MCT-550 SMA mounts on the wall, avoiding damage due to water exposure, and uses a 10ft long sensor cable to detect water at floor level. Specifications Installation Pairing Resetting Features and Specifications Detects water…
Defaulting SMC Water Sensor
To default the sensor, remove the battery. While pressingthe black Tamper/Default button located near the battery carrier and the wire contacts, insert the battery. Then release the button.
SMC Water Sensor (SMCWA10-Z)
The water sensor allows users to around the clock remotely detect the presence of water to provide early detection of costly leaks and floods that could be caused from sump pumps, water heaters, air conditioners, heavy rains, and more. The SMCWA10-Z consists of a Zigbee transceiver unit, 20ft cable, and…
Deleting/Modifying a Sensor
When you delete a sensor, Touchstone disables any rules that reference the sensor. To delete a sensor, click SETTINGS on the toolbar to display the settings page. Click the type of sensor that you would like to delete to display the sensor’s settings page. Click the icon next to the…
Adding a Sensor
Sensors can be added to your system during activation, or at a later time. If you want to add a sensor that was not included with the original Touchstone package, make sure your service provider supports it. Note: If you are attempting to pair a sensor that has been previously deleted…
Defaulting the Visonic Water Sensor (MCT-550 SMA)
To default the Water Sensor, remove the cover by loosening the screw found at the top of the unit. Remove the battery and depress the tamper spring. Reinsert the battery, immediately release the tamper spring, and press and release the tamper spring again. The LED on the sensor will begin…